EP ThermoSolutions™

Frequently Asked Questions — Insulation

The insulation questions Mid-Michigan homeowners ask us most.

What areas of the home should be insulated first?

In most Mid-Michigan homes, the attic is the highest-impact, lowest-cost place to start. Air sealing and attic insulation together address the biggest heat loss before we look at walls, basements, or crawlspaces.

What's the difference between blown-in and spray foam?

Blown-in cellulose is the value workhorse for attics and fills over existing insulation. Spray foam adds air sealing and structure in one step and is ideal for rim joists, additions, and hard-to-insulate cavities. We'll recommend the right one for each area.

How do I know if my attic insulation is low?

If you can see the joists, the insulation is below the top of the wood — that's too low for Michigan. Uneven coverage, gaps, or discolored patches are also signs. We measure the existing depth during the visit.

Can you insulate existing walls without tearing out drywall?

Yes. Dense-pack cellulose and injection foam are installed from the outside through small access holes, so the interior drywall stays in place. It's a retrofit solution for homes with empty or under-insulated wall cavities.

Does insulation help in summer too?

Yes. Insulation resists heat flow in both directions, so a well-insulated attic keeps summer heat out and reduces cooling run time. Air sealing also keeps humid outside air from entering.

Will insulation reduce drafts?

Insulation reduces conductive heat loss, but drafts are mostly air leakage. That's why we air seal before adding insulation — sealing gaps at the top plate, can lights, and penetrations stops the drafts that insulation alone can't.

How long does an insulation project take?

Most attic insulation jobs are done in a day. Retrofit wall and spray foam projects can run one to two days depending on scope. We'll give you an honest timeline at your visit.

Is insulation messy?

Blown-in cellulose is contained to the attic and we protect the work area. Retrofit wall work is done from the exterior. We clean up thoroughly and remove debris as part of every package.

What R-value do I need?

For Mid-Michigan attics, R-49 to R-60 is the common target. Our ComfortCore packages go from R-28 (8″) up to R-70 (20″). We measure the existing depth and recommend the depth that fits your home.

Will insulation pay for itself?

Air sealing and attic insulation typically have the fastest payback of any home improvement because they reduce heating and cooling run time every day. We document the work for any available utility rebates and tax credits.

What's the difference between open-cell and closed-cell spray foam?

Open-cell is softer, lower cost, and good for interior cavities. Closed-cell is denser, adds structural rigidity, and resists moisture — it's the choice for crawlspaces, rim joists, and below-grade walls. We'll recommend the right one for each area.

Is air sealing more important than adding insulation?

Insulation slows heat moving through materials. Air sealing stops conditioned air from leaking out through gaps and cracks. Both are needed — insulating without sealing lets air bypass the insulation, which is why we seal first.

Can insulation help with ice dams?

Yes. Ice dams form when a warm attic melts snow that refreezes at the cold eaves. Air sealing and consistent attic insulation keep the roof deck cold so snow melts evenly. Ventilation and baffles are part of the fix.

Do you cover recessed lights and attic penetrations?

Recessed lights, bath fans, and chimneys are major air-leak paths. We install covers where required by code and seal around penetrations before insulating so the insulation performs as intended.

Will insulation reduce dust in my home?

Air sealing reduces the amount of unconditioned, dusty air pulled in from the attic and walls, so many homeowners notice less dust after air sealing and insulation work.

Can insulation help rooms over garages?

Rooms over an unconditioned garage are often cold because the floor cavity is under-insulated. We can insulate and air seal the floor cavity from below to bring those rooms closer to the rest of the house.

How do you know how much insulation is in my attic?

We measure the existing depth at several points across the attic, note the type and condition, and check for gaps, voids, and discolored patches. That tells us what's there and what depth gets you to the target R-value.

Do you remove old insulation?

Not usually. INSULMAX® cellulose is blown over existing insulation to fill gaps and add depth. We only recommend removal if the existing insulation is contaminated, compressed, or water-damaged — we'll tell you at the inspection.

Is spray foam always the best choice?

No. Spray foam is excellent for air sealing and hard-to-insulate areas, but blown-in cellulose is often the better value for open attics. We recommend the right material for each area rather than one product for everything.

Will insulation make my HVAC run less?

Yes. By reducing heat loss in winter and heat gain in summer, insulation and air sealing let your HVAC system maintain comfort with shorter run times — which can extend equipment life and lower energy bills.

Still have a question?

We're happy to talk it through — no pressure, no obligation.

CallBookGet My Price